- Start with a side part and slightly damp in the crown section.
- Spray with water and spray gel.
- Part off the crown section and clip out of the way.
- Part down the center back.
- Place your finger at the bottom of the nape and take the comb from the top down to your finger.
- Secure the pigtails with an elastic.
- Use more water and spray gel if needed.
- Take the crown section out of the clip.
- Part off a one inch diagonal section close to the part line.
- Split into three.
- Start a dutch braid by crossing the out side pieces underneath the middle section.
- Now add a section to the left piece and cross under the middle.
- Add a section to the right piece and cross under the middle.
- Use a smoothing brush if needed.
- Continue adding hair to each side and crossing under the middle until you have added in all of the hair from the crown section.
- Now simply three strand braid until the braid reaches the right side pigtail.
- Secure with an elastic.
- Smooth the pigtail.
- Add an elastic about 2-3 inches down the pigtail.
- Now gently pull at either side of the bubble (between the two elastics)
- Use a comb to smooth it if needed.
- Repeat a few inches down.
- Add another elastic and then gently pull to form the bubble.
- Repeat until you reach the end of the hair.
- Then repeat on the other pigtail.
- Add bows like these from www.labellebabybows.etsy.com
Find
more products we recommend here: https://www.amazon.com/shop/teswood
Find us on Instagram @teswood (www.instagram.com/teswood ) and
Facebook Q's Hairdos (www.facebook.com/qshairdos
)
No comments:
Post a Comment